Electrolux EKK6450AOX Manuel d'utilisateur télécharger pdf (Page 9)

Refer to "Care and cleaning"

chapter.

Clean the appliance before first use.

Put the accessories and the removable

shelf supports back to their initial

position.

4.2 Setting the time

You must set the time before you

operate the oven.

The indicator for the Time of day function

flashes when you connect the appliance

to the electrical supply, when there was a

power cut or when the timer is not set.

Press the

or button to set the

correct time.

After approximately five seconds, the

flashing stops and the display shows the

time of day you set.

4.3 Changing the time

You cannot change the time

of day if the Duration or

End function operates.

Press again and again until the

indicator for the Time of Day function

flashes.

To set a new time, refer to "Setting the

time".

4.4 Preheating

Preheat the empty appliance to burn off

the remaining grease.

1. Set the function

and the maximum

temperature.

2. Let the appliance operate for 1 hour.

3. Set the function and the maximum

temperature.

4. Let the appliance operate for 15

minutes.

5. Set the function and the maximum

temperature.

6. Let the appliance operate for 15

minutes.

Accessories can become hotter than

usual. The appliance can emit an odour

and smoke. This is normal. Make sure

that the airflow in the room is sufficient.

5. HOB - DAILY USE

WARNING!

Refer to Safety chapters.

5.1 Ignition of the hob burners

Always light the burner

before you put on the

cookware.

WARNING!

Be very careful when you

use open fire in the kitchen

environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

1. Push the knob for the hob down and

turn it to the position .

2. Keep the knob for the hob pushed for

equal or less than 10 seconds to let

the thermocouple warm up. If not, the

gas supply is interrupted.

3. Adjust the flame after it is regular.

WARNING!

Do not keep the knob

pushed for more than 15

seconds. If the burner does

not light after 15 seconds,

release the knob, turn it into

the off position and try to

light the burner again after

minimum 1 minute.

If after some tries the burner

does not light, check if the

crown and its cap are in the

correct position.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire