Electrolux EWF129442W Manuel d'utilisateur

EWF 129442 W... ...EN WASHING MACHINE USER MANUAL

SELECT THE REQUIRED PROGRAMMEBY TURNING THE PROGRAMMESELECTOR DIAL (1)Turn the programme selector dial to the re-quired programme. The washing machine

2. Select the delay start by pressing thebutton 6.3. Press button 8:– the machine starts its hourly count-down.– The programme will start after thesel

OPENING THE DOORAfter the programme has started (or duringthe delay time) the door is locked, if youneed to open it, set first the machine toPAUSE by

the cellulose structure will already havebeen damaged and the fabric tends to hole.Mould stains: treat with bleach, rinse well(whites and fast coloure

WASHING PROGRAMMESProgramme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Spin Speed -Maximum Fabrics Load - Type of LaundryOptions

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Spin Speed -Maximum Fabrics Load - Type of LaundryOptionsDetergent Com-part

Programme - Maximum and Minimum Tempera-ture - Cycle Description - Maximum Spin Speed -Maximum Fabrics Load - Type of LaundryOptionsDetergent Com-part

Programmes Load(kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approximateprogrammeduration (mi-nutes)Remainingmoisture(%)1)Standard 60 °Ccotto

Flush it out under a tap, to remove anytraces of accumulated powder.To aid cleaning, the top part of the additivecompartment should be removed. Clean

1. Open the pump door.2. Put a container below the recess of thedrain pump to collect the water thatflows out.3. Press the two levers and pull forward

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Safety instructions 3Product description

refitting the pump cover, ensure it is se-curely re-tightened so as to stop leaks andyoung children being able to remove it.CLEANING THE WATER INLETFI

WHAT TO DO IF…Certain problems are due to lack of simplemaintenance or oversights, which can besolved easily without calling out an engi-neer. Before

Problem Possible cause/SolutionThere is water on the floor:Too much detergent or unsuitable detergent (creates too muchfoam) has been used.• Reduce th

If you are unable to identify or solve theproblem, contact our service centre. Beforetelephoning, make a note of the model, se-rial number and purchas

3. Unscrew the three bolts.4. Slide out the relevant plastic spacers.5. Open the porthole. Remove the poly-styrene block fitted on the door seal.Remov

2. Do not place the inlet hose downwards.Angle the hose to the left or right de-pending on the position of your watertap.3. Set the hose correctly by

collection point for the recycling of electricaland electronic equipment. By ensuring thisproduct is disposed of correctly, you willhelp prevent poten

electrolux 27

www.electrolux.com/shop 132930791-A-162013

• Obey the maximum load volume of 9 kg (refer to the “Pro-gramme chart” chapter).• If the supply cord is damaged, it must be replaced by themanufactur

• Before you connect the appliance to newpipes or pipes not used for a long time,let the water flow until it is clean.• The first time you use the app

DETERGENT DISPENSER DRAWER Compartment for detergent used forprewash and soak phase or for stain re-mover used during the stain action phase (ifavaila

CONTROL PANELBelow is a picture of the control panel. It shows the programme selector dial as well asthe buttons, pilot light and the display. These a

DISPLAY7.4 7.5 7.17.3 7.2The display shows the following informa-tion:7.1:•Duration of the selected programmeAfter selecting a programme, the duration

PROGRAMME SELECTOR DIALIt allows you to switch the appliance on/offand/or to select a programme.TEMPERATUREThis button allows you to increase or de-cr

fault). By pressing these 2 buttons again,the acoustic signal is reactivated.CHILD SAFETY LOCKThis device permits you to leave the appli-ance unattend