Electrolux GHL246SW Manuel d'utilisateur télécharger pdf (Page 20)

1. Pull the front of the shelf support

away from the side wall.

2. Pull the rear end of the shelf support

away from the side wall and remove

it.

Install the shelf supports in the opposite

sequence.

11.5 Removing and installing

the door

You can remove the door to clean it.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A)

on the two door hinges.

3. Close the door until it is at an angle

of approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, install

the door. Do the above steps in the

opposite sequence.

12. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

12.1 What to do if...

Problem Possible cause Remedy

The flame ring is uneven. Burner crown is blocked

with food residues.

Make sure that the injector

is not blocked and the

burner crown is clean.

The burners do not work. There is no gas supply. Check the gas connection.

www.electrolux.com20

1 2 ... 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Electrolux GHL246SW Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Electrolux GHL246SW