Electrolux IEB4SL80CN Manuel d'utilisateur télécharger pdf (Page 41)

Do not open the door during

the heating up time. If you

open the door, you will

cancel the pyrolytic cleaning

cycle.

3. To stop the pyrolytic cleaning cycle,

touch .

Do not use the appliance until the door

lock symbol is off.

12.4 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully lift up the clamping levers (A)

on the two door hinges.

A

A

3. Close the door until it is at an angle

of approximately 45°.

45°

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface.

This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides and

push inwards to release the clip seal.

1

2

B

CAUTION!

Rough handling of the glass,

especially around the edges

of the front panel, can cause

the glass to break.

7. Pull the door trim to the front to

remove it.

8. Hold the door glass panels on their

top edge one by one and pull them

up out of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.

When the cleaning is completed, do the

above steps in the opposite sequence.

Install the smaller panel first, then the

larger and the door.

WARNING!

Make sure that the glasses

are inserted in the correct

position otherwise the

surface of the door may

overheat.

12.5 Replacing the lamp

Put a cloth on the bottom of the interior

of the appliance. It prevents damage to

the lamp glass cover and the cavity.

ENGLISH 41

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Commentaires sur ces manuels

Pas de commentaire