Electrolux AFP700 Manuel d'utilisateur télécharger pdf (Page 57)

g

57

5 Coarse rasp

For coarse rasping of vegetables

and fruit, etc.

6 Fine rasp

For fine rasping of vegetables,

fruit, chocolate, garlic, etc.

Preparing multifunction section

Fit safety cover (fig. 4)

The multifunction section can only be

put into operation when the mix con-

tainer is removed and the safety cover

for the mixer drive (figs. 1/S and 4) is

fitted.

0 Remove mix container as described

under "Mixer".

– The red warning lamp (fig 4/a)

flashes.

0 Place safety cover on mixer drive (mark

on mark ) and turn counter-

clockwise to the stop. The safety cover

is heard to engage. The mark must

be above the warning lamp (fig. 4).

– The red warning lamp (fig. 4/a)

extinguishes.

Fitting all-purpose bowl (fig. 5)

0 Place all-purpose bowl (fig. 1/G) on

appliance (arrow on arrow )

and turn counter-clockwise to the

stop. The all-purpose bowl can be

heard to engage. The two black arrows

must coincide.

Inserting spindle (fig. 7)

0 Place spindle (fig. 1/H) on spigot in

centre of all-purpose bowl.

Inserting tools

The following tools can be selected for

insertion:

• Whisking disk (fig. 1/Q) or

• Metal blade (fig. 1/P) or

• Plastic blade (fig. 1/O) or

• Insert holder (fig. 1/N) with cutting

insert (fig. 9)

3

The insert holder must be fitted with

the appropriate insert depending on

the purpose of application (see "Insert-

ing cutting insert in insert holder").

0 Place desired tool on spindle.

– Whisking disk, metal blade and plas-

tic blade (fig. 8) mesh with the teeth

underneath on the spindle.

– The insert holder (fig. 11) rests on

the hexagonal spindle.

3

Preferably hold the insert holder with

two fingers in the two handle holes.

Fitting the cover (fig. 6)

0 Place cover (fig. 1/F) on the all-purpose

bowl (arrow on arrow ) and

turn counter-clockwise to the stop.

The cover can be heard to engage. The

nose of the cover is then directly above

the handle, both black arrows must

coincide.

0 Insert stopper (fig. 1/E) in filling inlet.

Inserting cutting insert in insert

holder (fig. 10)

The appropriate insert must be placed

in the insert holder depending on use.

3

The inserts are contained in the hinged

accessories compartment (fig. 1/K) in

the motor casing.

1

The inserts are very sharp. They should

be held only with the handle!

0 Open accessories compartment by

pulling the handle (fig. 9).

0 Take required insert by the handle from

the accessories compartment (fig. 9).

0 Place the insert with the tip at the cen-

tre of the insert holder and place in the

recess of the disk (fig. 10).

0 To remove the insert draw slightly out-

wards with the handle and raise.

822_949_277 AFP700_750_Elux.book Seite 57 Dienstag, 22. Januar 2008 8:02 20

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 275 276

Commentaires sur ces manuels

Pas de commentaire