Electrolux EPI09LEIWI Manuel d'utilisateur télécharger pdf (Page 15)

ENGLISH 14

6.4. Anti-cold air function

In HEAT mode, the indoor fan will not

operate in order to prevent cold air from

blowing out if the indoor heat exchanger

does not reach a certain temperature in

one of the following situations:



when the heating operation starts;

 when the defrosting operation is

finished;

 when heating at low temperature.

6.5. Gentle breeze

The indoor unit may blow gentle breeze

and the horizontal louvre rotates to

acertain position in one of the following

situations:



In HEAT mode, the compressor does

not start operation after switching on

the unit.

 In HEAT mode, the temperature

reaches the set value and the

compressor has stopped operation for

1 minute.

6.6. Opetaring temperature

range

The operating temperature range for

cooling-only units is 0-50 ˚C. The

operating temperature range for heat-

pump units is -15-(+30)˚C.

Indoor side (°C) Outdoor side (°C)

Max. cooling 32 50

Min. cooling 17 0

Max. heating 30 30

Min. heating 0 -15

6.7. Tip for energy saving

 Do not overcool or overheat. Setting

the temperature at a moderate level

helps energy saving.

 Cover windows with a blind or a

curtain. Blocking sunlight and air from

outdoor is favorable for cooling.

 Clean air filters every two weeks.

Clogged air filters lead to inefficient

operation and energy waste.

6.8. Tip for relative humidity

 If the unit is operated in an area with

a relative humidity of more than 80%

for a long time, condensate may drip

from the indoor unit.

7. INSTALLATION

7.1. Installation notes

 Not following the instructions can

cause personal injury and/or property

damage.

 Not following the instructions can

cause the unit to fail.

 Let the unit be installed by an

authorised service centre.

 Let the unit be installed in compliance

with local and governmental

regulations.

 Let the unit be installed according to

the instructions from this manual.

 First contact an authorised service

centre before relocating an already

installed unit

 Disconnect power before working on

the unit.

 The mains plug must remain

accessible after installation.

 Keep sufficient distance between the

interconnection cable and the

refrigerant circuit because the circuit

operating temperature is high.

 The pipes connecting the indoor and

outdoor unit are not included in the

unit.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 97 98

Commentaires sur ces manuels

Pas de commentaire