Electrolux EPI09LEIWI Manuel d'utilisateur télécharger pdf (Page 20)

19 www.electrolux.com

Drill piping hole

1. Slant the piping hole (Ø 65 mm) on

the wall slightly downward to the

outdoor side.

2. Insert the piping-hole sleeve into the

hole to prevent damage to the

connection piping and wiring.

Installing the drain hose

1. Connect the drain hose to the outlet

pipe of the indoor unit. Bind the joint

with rubber belt.

2. Put the drain hose into the insulating

tube.

3. Wrap the insulating tube with wide

rubber belt to prevent the insulating

tube from shifting. Slant the drain

hose slightly downward for smooth

drainage of the condensate water.

NOTE



The insulating tube must be

connected reliably with the sleeve

outside the outlet pipe. The drain

must be slanted downward slightly

without distortion, bulge or fluctuation.

Do not put the outlet of the drain hose

in water to prevent the drain hose

from freezing.

Wiring connection of indoor unit

Terminal block of indoor unit

CAUTION



Check the wiring to make sure that

there is no short circuit. Incorrect

wiring can cause malfunction.



Ensure the colour of wires of outdoor

unit and the terminal Nos. are the

same to the indoor’s respectively.



The indoor power cord (purchared on

local) type is H05VV-F or H05V2V2-F,

the outdoor power cord and

interconnected cord type is H07RN-F.

150mm or more to ceilin

g

Right rear side

refrigerant pipe

hole Ø 65

120mm or

more to wall

Installation plate

24000Btu/h models

120mm or

more to wall

Indoor unit outline

Left rear side

refrigerant pipe

hole Ø 65

Front Panel

Electronic

box cover

Wall

Indoor

Outdoor

5-7 mm

To outdoor unit

W

2(N)

S

1(L)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 97 98

Commentaires sur ces manuels

Pas de commentaire