Electrolux EBGL3SP Manuel d'utilisateur télécharger pdf (Page 24)

2.

Install the shelf supports.

10.3 Removing / inserting the

door

To clean the door remove it.

A

A

CAUTION!

Be careful when you remove the

door from the appliance. The door

is heavy. There is a risk of injury or

damage to the appliance.

Removing the door

1.

Open the door as far as it goes.

2.

Press down the clamping levers (A)

on the two door hinges.

45°

3.

Close the door until it is at an angle

of approximately 45°.

4.

Hold the door with one hand on each

side and pull it away from the appli-

ance at an upwards angle.

Put the door with the outer side

down on a soft and level surface

to prevent scratches.

Inserting the door

To insert the door do the above steps in

the opposite sequence.

10.4 Lamp

WARNING!

Danger of electrocution! Discon-

nect the fuse before you replace

the lamp.

The lamp and the lamp glass cov-

er can be hot.

Before you change the lamp:

• Deactivate the appliance.

• Remove the fuses from the fuse box or

deactivate the circuit breaker.

CAUTION!

Put a cloth on the bottom of the

interior of the appliance. It pre-

vents damage to the lamp glass

cover and the cavity.

Always use the same lamp type.

Replacing the top lamp:

1.

Turn the lamp glass cover counter-

clockwise to remove it.

2.

Clean the glass cover.

3.

Replace the lamp with a halogen, 230

V, 40 W, 300 °C heat resistant oven

lamp.

4.

Install the glass cover.

Replacing the side lamp:

1.

Remove the left shelf support to get

access to the lamp.

2.

Use a narrow, blunt object (e.g. a tea-

spoon) to remove the glass cover.

Clean the glass cover.

24

www.electrolux.com

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire