Electrolux WTSL6E200 Manuel d'utilisateur télécharger pdf (Page 44)

• Connect the water inlet hose to the cold

water tap with 3/4 thread.

CAUTION!

Make sure that there are no

leaks from the couplings.

Do not use an extension hose if the inlet hose is too short. Contact the

service centre for the replacement of the inlet hose.

16.6 Water-stop device

The inlet hose has a water stop device. This

device prevents water leaks in the hose

because of its natural ageing.

The red sector in the window «A» shows this

fault.

If this occur, close the water tap and contact

the service centre to replace the hose.

16.7 Water drainage

There are different procedures to connect the drain hose:

With the plastic hose guide:

• Making an U form with the drain hose.

On the edge of a sink

• Make sure that the plastic guide cannot

move when the appliance drains. Attach the

guide to the water tap or the wall.

www.electrolux.com44

1 2 ... 39 40 41 42 43 44 45 46 47 48

Pas de commentaire

Electrolux WTSL6E200 Manuel d'utilisateur Page 44